WTB: Conn SL2525 slide with 3 leadpipes

ttf_ebrenner · Post by **ttf_ebrenner** » Fri Jun 02, 2017 9:39 am

If you have one to sell, please send me an email at [url=mailto:[email protected]][email protected][/url]. Thanks.

ttf_hyperbolica · Post by **ttf_hyperbolica** » Fri Jun 02, 2017 10:12 am

I have a .525 slide with a press fit Brass ARk MV36. Only played a few months. Comes with an Elkhart 8h bell. Might be willing to separate them. The slide is not the stock sl2525.

ttf_ebrenner · Post by **ttf_ebrenner** » Fri Jun 02, 2017 8:29 pm

What is the make and material of the slide?

ttf_ebrenner · Post by **ttf_ebrenner** » Sat Jun 03, 2017 1:38 pm

Thanks. Before discussing further I would like to wait and see if a Conn SL2525 is available.

ttf_hyperbolica · Post by **ttf_hyperbolica** » Sat Jun 03, 2017 9:35 pm

It's a custom slide made by a tech on the forum from Conn parts. Yellow outers, yellow crook.

ttf_ebrenner · Post by **ttf_ebrenner** » Mon Jun 05, 2017 7:36 pm

How much would you be asking for the custom slide?

ttf_hyperbolica · Post by **ttf_hyperbolica** » Tue Jun 06, 2017 6:02 am

Quote from: ebrenner on Jun 05, 2017, 07:36PMHow much would you be asking for the custom slide?

$500 including the leadpipe. It was built 6-8 months ago, and has a couple hours play time on it. Never played outside the house. See the slide with the rest of the horn here: https://www.dropbox.com/sh/o1qos7rzcb6bqdw/AABlldQ4zZSQPxYOUtrOnoCEa?dl=0

ttf_DaveAshley · Post by **ttf_DaveAshley** » Tue Jun 06, 2017 8:04 am

I'd probably be willing to part with mine. It's in excellent+ condition, and has the three leadpipes (including the large shank X pipe). It's nice, but I almost never play anything larger than .500 bore.

I'll be home from my ship gig on June 23. If you don't find one by then write to me at [url=mailto:[email protected]][email protected][/url] (put my username before "jazz")

I'll sell it for what I paid for it (I bought it here not long ago - You can find my reply to the seller's post in my past posts)