Page 1 of 1

Air leak near rotary

Posted: Thu Nov 26, 2020 5:01 pm
by woahthereT
Little bit of background: I recently bought a Blessing b-88 open wrap. At first testing it out I didn't notice anything wrong with it. However, at home I noticed that if I'd play a scale that used the f-attachment, the way down sounded awkward and airy(for example: the c-major scale, the low c wouldn't come out properly).

Any help would greatly be appreciated on what to do.

Re: Air leak near rotary

Posted: Thu Nov 26, 2020 5:23 pm
by Burgerbob
Is the valve well oiled?

Re: Air leak near rotary

Posted: Thu Nov 26, 2020 5:28 pm
by Elow
One way to check is to pull the tuning slide all the way out and if there is a good pop then that means there’s usually decent compression but if there’s no pop then there’s a problem. Also, is it just low C or all trigger notes? Can you play low C on a different horn?

Re: Air leak near rotary

Posted: Thu Nov 26, 2020 5:36 pm
by woahthereT
Burgerbob wrote: Thu Nov 26, 2020 5:23 pm Is the valve well oiled?
Yes it is very oiled and cleaned.

Re: Air leak near rotary

Posted: Thu Nov 26, 2020 5:41 pm
by woahthereT
Elow wrote: Thu Nov 26, 2020 5:28 pm One way to check is to pull the tuning slide all the way out and if there is a good pop then that means there’s usually decent compression but if there’s no pop then there’s a problem. Also, is it just low C or all trigger notes? Can you play low C on a different horn?
Sort of ? The pop is very faint. It is all notes an on another horn I can play just

Re: Air leak near rotary

Posted: Thu Nov 26, 2020 6:46 pm
by Elow
Do all the notes sound like low C? How does F sound at forte?

Re: Air leak near rotary

Posted: Thu Nov 26, 2020 8:40 pm
by woahthereT
Elow wrote: Thu Nov 26, 2020 6:46 pm Do all the notes sound like low C? How does F sound at forte?
When it happens all notes still play just very ugly and airy.

Re: Air leak near rotary

Posted: Thu Nov 26, 2020 8:56 pm
by Bonearzt
Check the rotor alignment bumpers and bumper plate, the plate is usually plastic and easily cracked. Also check the water key cork, and make sure the knuckle from the slide receiver isn't cracked or unsoldered.

Just a few starting points!

Eric