TromboneChat

Hi all,

Could anyone with calipers and a 354 slide tell me the OD on the outer slide tubes (in the main length, not the thicker-drawn sleeves at the top)?

By way of advance payment, please enjoy this video of red pandas playing in the snow.

Calipers may suffice for your purpose(s). Bore gages and a micrometer are more accurate.

For my porpoise, I will gratefully accept caliper or mic measurements

ithinknot wrote: ↑Wed May 25, 2022 6:30 am For my porpoise, I will gratefully accept caliper or mic measurements

According to this image, an adult porpoise is roughly 1.4-1.9M...

Unfortunately, I don't have a good measurement for the YSL 354.
--Andy in OKC

ps., I'll show myself out now.

But you didn't measure the girth (OD)

I think ithinknot's autocorrect misinterpreted "purpose"

BGuttman wrote: ↑Wed May 25, 2022 7:27 am But you didn't measure the girth (OD)

I think ithinknot's autocorrect misinterpreted "purpose"

I'm pretty sure the porpoise girth measurement is 1 girth unit.
However, I'm not sure about the conversion factors for either imperial or metric measurements.

--Andy in OKC
(and I bet you're correct - but not autocorrect!)

BGuttman wrote: ↑Wed May 25, 2022 7:27 am I think ithinknot's autocorrect misinterpreted "purpose"

I don't make mistakes

ithinknot wrote: ↑Wed May 25, 2022 1:55 pm

BGuttman wrote: ↑Wed May 25, 2022 7:27 am I think ithinknot's autocorrect misinterpreted "purpose"

I don't make mistakes

You mean you were actually asking about a large marine mammal?

Specs I measured many years ago

Inner slide:
Bore .500
O.D. .523
Stocking OD .532

Outer slide:
I.D. .542
O.D. .561

Doug Elliott wrote: ↑Wed May 25, 2022 7:17 pm Specs I measured many years ago

Perfect. Thanks very much!