FS: .562 bore four-valve bass valve trombone. $1100.
Posted: Wed Aug 30, 2017 8:00 am
The air compressor in the shop gave out, so I'm in need of cash. I'm selling the valved bass trombone I built. The bore is .562 through the valve section. The bell is from a Holton TR680. It uses a threaded bass trombone leadpipe, with a very cool adapter made by Mike Olsen that can accommodate both coarse and fine-thread leadpipes, and a Shires nickel leadpipe. The trigger is activated with a Yamaha trumpet first-valve trigger with just enough throw to activate the valve. Comes in a case I got from Bob Ramsdell at ValvetrobonesRUs.com which is an excellent fit. The trigger linkage is on quick-release connectors, so it's easy to disassemble.
The sound is exceptional. It's crackly and dark at the same time. Definitely not tubby. Having a trigger is a definite plus for playing in the low range. The valve action is better than I would have expected, with faster action than most euphoniums. The case (originally for a Conn valve/slide trombone) came out great. I've played horns set up like the DEG Jazzbone--same bore as this but with a tightly-wrapped valve section--and this horn has much better ergonomics and a brighter sound.
Lacquer is not perfect, with some flux bleed around the thin nickel sheets soldered to the valve cluster, and other areas where it's hazy. There's some erosion of the brass on parts of the valve cluster. The trigger is at its absolute limit for adjustment, and I had to loctite the connectors to the rod to make sure that it didn't change dimensions. Finally, the bell is not as far in front of my left hand as I'd like it to be, and my knuckles are very close to the bell rim. Aside from that, it's a fantastic horn.
Shipping will be high, as this trombone and case are somewhere in the area of 30 pounds.
Email with any questions.
The sound is exceptional. It's crackly and dark at the same time. Definitely not tubby. Having a trigger is a definite plus for playing in the low range. The valve action is better than I would have expected, with faster action than most euphoniums. The case (originally for a Conn valve/slide trombone) came out great. I've played horns set up like the DEG Jazzbone--same bore as this but with a tightly-wrapped valve section--and this horn has much better ergonomics and a brighter sound.
Lacquer is not perfect, with some flux bleed around the thin nickel sheets soldered to the valve cluster, and other areas where it's hazy. There's some erosion of the brass on parts of the valve cluster. The trigger is at its absolute limit for adjustment, and I had to loctite the connectors to the rod to make sure that it didn't change dimensions. Finally, the bell is not as far in front of my left hand as I'd like it to be, and my knuckles are very close to the bell rim. Aside from that, it's a fantastic horn.
Shipping will be high, as this trombone and case are somewhere in the area of 30 pounds.
Email with any questions.